Bowling
 
Bowling

A bowler delivers the ball toward the batsmen, using what is known as a bowling action: the elbow may be held at any angle and may bend further, but may not straighten out during the action. If the elbow straightens, it is an illegal throw and the delivery is called a no-ball. Under new cricketing law, after consultation with health experts, the bowler is allowed to straighten his arm 15 degrees or less; if the bowler straightens his arm more than 15 degrees it is called a "no ball".

Usually, the bowler pitches the ball so that it bounces before reaching the batsman. Some part of the bowler's front foot in the delivery stride (that is, the stride when the ball is released) must be behind the popping crease to avoid a no-ball (although the bowler's front foot does not have to be grounded). The ball must also be delivered so it is within the batsman's reach; otherwise it is termed a wide. A wide cannot be called if the batsman hits the ball. A wide or no-ball results in an extra run being added to the batting team's score, and an extra ball being bowled in the over.
  

The bowler's primary goal is to take wickets; that is, to get a batsman out or dismissed. If a bowler can dismiss the more accomplished batsmen on the opposing team he reduces the opportunity for them to score, as it exposes the less skillful non-specialist batsmen.

The bowler's secondary task is to limit the numbers of runs scored per over bowled. This is known as the Economy rate.

There are two main kinds of bowlers: pace bowlers, who attempt to bowl the ball too quickly for the batsman to properly react, and spin bowlers who bowl slower deliveries that bounce and curve in unpredictable ways.

























 
 
 
     
 
Dismissal of a batsman
 
Dismissal of a batsman

There are ten ways in which a batsman may be dismissed. Once a batsman is dismissed, he leaves the field to be replaced by another batsman. When the tenth batsmen is out, the remaining not-out batsman has run out of partners, at which point the side is "all out", and the innings is over.

Many modes of dismissal require the wicket to be "put down". The wicket is put down if a bail is dislodged from the top of the stumps; or if a stump is struck out of the ground either by the ball, or by a fielder using his hand which is holding the ball. Of the following ten modes of dismissal, the first six are common, while the last four are technicalities which rarely occur. Briefly, the ten modes are:

1. Caught — When a fielder catches the ball before it bounces and after the batsman has struck it with the bat or it has come into contact with the batsman's glove while it is in contact with the bat handle. The bowler and catcher are both credited with the dismissal.

2. Bowled — When a delivered ball hits the stumps at the batsman's end, and dislodges one or both of the bails. This happens regardless of whether the batsman has edged the ball onto the stumps or not. The bowler is credited with the dismissal.

3. Leg before wicket — When a delivered ball misses the bat and strikes the batsman's leg, pad or body, and the umpire judges that the ball would otherwise have struck the stumps. The laws of cricket stipulate certain exceptions. For instance, a delivery pitching outside the line of leg stump should not result in an lbw dismissal, while a delivery hitting the batsman outside the line of the off stump should result in an lbw dismissal only if the batsman makes no attempt to play the ball with the bat. The bowler is credited with the dismissal.

4. Run out — When a fielder, bowler or wicket-keeper removes one or both of the bails with the ball by hitting the stumps whilst a batsman is still running between the two ends. The ball can either hit the stumps directly or the fielder's hand with the ball inside it can be used to dislodge the bails. Such a dismissal is not officially credited to any player, although the identities of the fielder or fielders involved is often noted in brackets on the scorecard.

5. Stumped — When the batsman leaves his crease in playing a delivery, voluntarily or involuntarily, but the ball goes to the wicket-keeper who uses it to remove one or both of the bails through hitting the bail(s) or the wicket before the batsman has remade his ground. The bowler and wicket-keeper are both credited. This generally requires the keeper to be standing within arm's length of the wicket, which is done mainly to spin bowling. (Law 39)
6. Hit wicket — When the batsman accidentally knocks the stumps with either the body or the bat, causing one or both of the bails to be dislodged, either in playing a shot or in taking off for the first run. The bowler is credited with the dismissal.

7. Handled the ball — When the batsman deliberately handles the ball without the permission of the fielding team. No player is credited with the dismissal.

8. Hit the ball twice — When the batsman deliberately strikes the ball a second time, except for the sole purpose of guarding his wicket. No player is credited with the dismissal.

9. Obstructing the field — When a batsman deliberately hinders a fielder from attempting to field the ball. No player is credited with the dismissal.

10. Timed out — When a new batsman takes more than three minutes to take his position in the field to replace a dismissed batsman (If the delay is protracted, the umpires may cause the match to be forfeited). This rule prevents the batting team using time limits of the game to unfair advantage. No player is credited with the dismissal.








 
 
Copyright 2008 www.quickhaag.org - All Rights Reserved